License Plate Lamp: Service and Repair

LICENSE PLATE LAMP

LAMP - NORTH AMERICA

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Remove the two screws (3) that secure the license plate lamp unit (2) to the rear bumper fascia (1).
3. Lower the lamp from the mounting hole in the fascia far enough to access and disconnect the lamp pigtail wire connector.
4. Remove the license plate lamp unit from the vehicle

INSTALLATION




1. Position the license plate lamp unit (2) to the rear bumper fascia (1).
2. Reconnect the lamp socket pigtail wire connector.
3. Position the lamp unit into the mounting hole in the rear bumper fascia.
4. Install and tighten the two screws (3) that secure lamp unit to the fascia. Tighten the screws to 2 N.m (20 in. lbs.).
5. Reconnect the battery negative cable.