Idle Speed/Throttle Actuator - Electronic: Service and Repair

REMOVAL




The Idle Air Control (IAC) motor (3) is located on the side of the throttle body.
1. Disconnect electrical connector from IAC motor.
2. Remove two mounting bolts (screws) (4).
3. Remove IAC motor (3) from throttle body.

INSTALLATION




The Idle Air Control (IAC) motor (3) is located on the side of the throttle body.
1. Install IAC motor (3) to throttle body.
2. Install and tighten two mounting bolts (screws) (4) to 7 N.m (60 in. lbs.) torque.
3. Install electrical connector.