Front Seat Cushion

SEAT CUSHION - FRONT

WARNING: Before proceeding with the following repair procedure, review all warnings and cautions. Refer to Seats / Service Precautions.

REMOVAL




1. Remove the seat.
2. Remove the trim covers from each side.
3. Remove the screws and disconnect the recliner cable to the seat back hinges.




4. Remove the two bolts attaching the front of the cushion frame to the seat frame.
5. Remove the two bolts attaching the rear of the cushion frame to the seat frame.
6. Separate the seat cushion assembly from the seat assembly.




7. Separate the J-straps and remove the seat cushion and cover from the frame.




8. Remove the hog rings and remove the seat cushion cover.

INSTALLATION

NOTE: After replacing passenger front seat cushion and/or Occupant Classification Module (OCM) there may be a wire connector not used from the seat weight sensor. Secure wire connector to the seat cushion frame with wire ties.

1. Position the seat cushion cover over the seat foam cushion and install new hog rings.
2. Position the seat cushion onto the seat cushion frame and attach the J-straps.
3. Install the seat cushion onto the seat assembly and install the rear two bolts.
4. Install the front two bolts and tighten the bolts to 28 N.m (21 ft.lbs.).
5. Connect the recliner cables to the seat back hinges and install the screws.
6. Install the trim covers.
7. Install the seat.