Bulb

REPEATER LAMP

BULB

NOTE: Side repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Remove the repeater lamp unit from the front fender panel (1).
3. Rotate the repeater lamp socket (2) in the lamp lens (4) counterclockwise about 30 degrees to unlock it.
4. Pull the socket and bulb (3) straight out of the keyed opening in the lamp lens.
5. Pull the base of the bulb straight out of the lamp socket.

INSTALLATION

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket and/or the lamp wiring.




1. Align the base of the bulb (3) with the repeater lamp socket (2).
2. Push the bulb straight into the socket until the base is firmly seated.
3. Align the socket and bulb with the keyed opening on the back of the repeater lamp lens (4).
4. Insert the socket and bulb straight into the lens until the socket is firmly seated
5. Rotate the socket clockwise in the lens about 30 degrees to lock it into place.
6. Reinstall the repeater lamp unit onto the front fender panel (1).
7. Reconnect the battery negative cable.