Lamp

REPEATER LAMP

LAMP

NOTE: Side repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Using a trim stick or another suitable wide flatbladed tool, carefully pry at the clearance notch in the lower edge of the repeater lamp lens (1) to disengage the snap features of the lens from the mounting hole in the front fender panel (2).
3. Pull the lamp unit out from the front fender panel far enough to access and disconnect the wire harness connector from the lamp socket.
4. Remove the lamp unit from the front fender panel.

INSTALLATION




1. Position the repeater lamp unit (1) to the front fender panel (2).
2. Reconnect the wire harness connector to the lamp socket.
3. Position the lamp unit into the mounting hole in the front fender panel. Be certain that the clearance notch on the edge of the lamp lens is oriented towards the bottom.
4. Using hand pressure, press on the lamp lens firmly and evenly until the snap features of the lamp are fully engaged in the mounting hole of the front fender panel.
5. Reconnect the battery negative cable.