Front

PARK/TURN SIGNAL LAMP

LAMP

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Remove the screw (3) that secures the inboard side of the front park/turn signal lamp unit (1) to the front bumper fascia (4).




3. Pull the inboard side of the lamp (4) away from the fascia far enough to disengage the tab that secures the outboard side of the lamp from the slot (1) in the front bumper fascia.
4. Disengage the lock feature and disconnect the wire harness connector (2) from the lamp socket.
5. Remove the front park/turn signal lamp unit from the vehicle.

INSTALLATION




1. Check to be certain that the plastic nut (3) is in good condition and properly installed in the inboard side of the front park/turn signal lamp mounting hole in the front bumper fascia.
2. Position the lamp unit (4) near the mounting hole in the fascia.
3. Reconnect the wire harness connector (2) to the lamp socket and engage the lock feature.
4. Align and engage the tab on the outboard side of the lamp housing with the slot (1) in the fascia mounting hole.




5. Position the inboard side of the lamp (1) into the fascia (4) mounting hole.
6. Install and tighten the screw (3) that secures the inboard side of the lamp to the fascia. Tighten the screw to 2 N.m (20 in. lbs.).
7. Reconnect the battery negative cable.