Vanity Lamp: Service and Repair

VANITY LAMP

BULB

NOTE: Vehicles equipped with optional vanity lamps have a mirror with a lamp that is integral to each sun visor. Each lamp is independently controlled by an integral switch that is automatically actuated by the mirror cover. The bulb types and service procedures are identical for both of these lamps.

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Insert a small thin-bladed tool on either side of the mirror (2) near the top or the bottom between the vanity lamp lens (1) and the sun visor (3) vanity lamp housing.
3. Carefully pry the lens outward until it unsnaps from the lamp housing.




4. Using small needle-nose pliers (4), carefully grasp the bulb (5) and pull the base out of the lamp socket (3).

INSTALLATION

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket and/or the lamp wiring.




1. Using small needle-nose pliers (4), carefully grasp the vanity lamp bulb (5) and align the base of the bulb with the socket (3) in the lamp housing of the sun visor.
2. Push the bulb base straight into the socket until the base is fully seated.
3. Insert one tab on the top or the bottom of the lens into the appropriate slot at the top or the bottom of the lamp housing.
4. Flex the lens far enough to engage the loose tab into its slot in the lamp housing.
5. Reconnect the battery negative cable.