Rear

REMOVAL
1. Remove the rear fascia.

2. Remove the spare wheel.

3. Remove the tail lamps.




4. Disconnect the tire pressure monitor sensor, if equipped.




5. Separate the right harness hangers and position the harness through the cradle.




6. Disconnect the vapor canister electrical connector.




7. Disconnect the vapor canister hoses.




8. Loosen the upper two canister nuts.

9. Remove the lower canister nut (2) and remove the vapor canister (1).




10. Separate the left harness hangers and position the harness through the cradle.




11. Disconnect trailer wiring electrical connector (1).




12. Lube filler neck grommet to aid with removal of the filler neck.




13. Disconnect vapor canister line (2).

14. Disconnect the fuel line (1).

15. Loosen the clamp (4) and disconnect the fuel filler hose (3).




16. Remove the bolt (1) supporting the fuel filler tube (2).




17. Separate and remove the fuel filler neck.




18. Remove the outer bolt (2 and 3) and disconnect the track bar (1).




19. Separate the exhaust hangers (1 and 2) and support the exhaust.




20. Using a grease pencil or equivalent, mark the location of the body cradle (3) on the underbody to aid installation.

21. Support the cradle (3) with a suitable lifting device.

22. Remove the upper cradle bolts (2).

23. Remove the side cradle bolt (1).

24. Remove the rail bolts (4) and remove the cradle (3).