Operation CHARM: Car repair manuals for everyone.
Home >> Jeep Truck >> 2007 >> Commander 4WD V8-4.7L VIN N >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Cylinder Head Assembly >> Valve Cover >> Service and Repair >> Removal and Replacement >> Cover - Cylinder Head - Right >> Installation - Right Side

Installation - Right Side






INSTALLATION - RIGHT SIDE





CAUTION: Do not use harsh cleaners to clean the cylinder head covers. Severe damage to covers may occur.

1. Clean cylinder head cover and both sealing surfaces. Inspect and replace gasket as necessary.
2. Install cylinder head cover and hand start all fasteners (1). Verify that all double ended studs are in the correct location shown in.
3. Tighten cylinder head cover bolts and double ended studs to 12 Nm (105 in. lbs).
4. Install right rear breather tube and filter assembly.
5. Connect injector, ignition coil electrical connectors and harness retaining clips.
6. Install the oil fill tube.
7. Install PCV hose.
8. Install heater hoses.
9. Install air conditioning compressor retaining bolts.
10. Install accessory drive belt.
11. Fill Cooling system.
12. Install air cleaner assembly, resonator assembly and air inlet hose.
13. Connect battery negative cable.
pro multis · About Operation CHARM