Lamp - With Flashlight Feature

LAMP - WITH FLASHLIGHT FEATURE

NOTE: There are two types of cargo lamps available in this vehicle; one with and one without a removable flashlight feature.




1. Position the cargo lamp (1) with the flashlight removed close enough to the headliner to reconnect the headliner wire harness connector to the connector receptacle (4) on the back of the lamp.

2. Engage the two fixed retainers (5) into the rear edge of the headliner mounting hole.

3. Slide the lamp housing rearward far enough to obtain clearance between the front edge of the lamp housing and the front of the headliner mounting hole for the lamp.

4. Depress the two spring tabs (2) far enough to push the forward edge of the lamp housing up into the mounting hole in the headliner, then release the spring tabs to engage the back of the headliner substrate.

5. Align the snap clip retainer (3) with the hole in the upper liftgate opening header.




6. Press firmly and evenly upward on the center of the flashlight receptacle in the cargo lamp housing (1) until the snap clip retainer on the back of the lamp snaps into place in the hole in the upper liftgate opening header (3).

7. Reinstall the push pin fastener (4) adjacent to each side of the cargo lamp that secures the headliner (5) to the upper D-pillar reinforcement (2).

8. Reinstall the trim onto the inside of both upper D-pillars.

9. Reinstall the flashlight into the cargo lamp housing.

10. Reconnect the battery negative cable.