Removal

REMOVAL

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, occupant classification system, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.

WARNING: To avoid serious or fatal injury on vehicles equipped with the Occupant Classification System (OCS), do not modify the front passenger seat assembly or center floor console in any way. Do not use any prior year, subsequent year, secondary or aftermarket seat trim covers. At no time should any Supplemental Restraint System (SRS) or OCS component be modified or replaced with any part except those which are specified for the particular vehicle application in the DaimlerChrysler Mopar(R) Parts Catalog. Failure to observe these precautions could cause an OCS miscalibration condition, which may result in the passenger airbag failing to deploy when required or deploying when not required.

WARNING: To avoid serious or fatal injury, never strike or drop a seat weight sensor or the passenger side front seat assembly to which the sensors are secured as it can damage the sensors or affect their calibration. The seat weight sensors and the passenger side front seat assembly must be handled with care to avoid damage to the sensors. Do not sit upon or place any loads upon a passenger side front seat while it is removed from its mounts in or outside of the vehicle. If an individual sensor is dropped or damaged, replace the sensor with a new and unused unit. If a seat has been dropped during removal or loaded while removed from its mounts, replace each of the seat weight sensors with new and unused units. Failure to observe this warning could result in an accidental, incomplete, or improper passenger side front supplemental restraint deployment.




1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.

2. Remove the passenger side front seat from the vehicle.

3. From the underside of the seat, disconnect the seat wire harness from the connector receptacles of each of the four weight sensors.

4. Disconnect the seat wire harness from the connector receptacle of the seat track position sensor located on the inboard side of the outboard seat adjuster upper track near the rear of the seat track.

5. Remove the seat cushion from the passenger side front seat.

CAUTION: A strain gauge alignment tool (Special Tool No. 9689) (2) must be used to secure the body of the seat weight sensor (1) from any rotation during removal or installation of the nut that secures the sensor stud to the seat cushion frame. In addition, the sensor fasteners should always be serviced using hand tools ONLY, and not electric or pneumatic power tools. Failure to observe these cautions may result in irreversible sensor damage requiring sensor replacement.




6. Install the strain gauge alignment tool (Special Tool 9689) on the sensors by inserting the center fork (1) of the tool between the flats on each side of the sensor body and inside of the cage, then seating the tool support yoke (2) firmly against the outside of the sensor cage.




7. With the alignment tool securing the body of the seat weight sensor (2), remove the nut (1) that secures the sensor stud to the seat cushion frame (3).

8. Transfer the special tool to each weight sensor, one at a time, and remove the nuts that secure the sensor studs to the seat cushion frame until all four nuts have been removed.

9. Carefully separate the seat cushion frame from the seat weight sensor studs.

10. Remove the two nuts that secure the sensor to the studs on the upper track of the seat adjuster (4).

11. Remove the seat weight sensor from the seat adjuster.