Fluid Drain And Fill

FLUID DRAIN AND FILL





NOTE: The fluid required for this transaxle is Mopar(R) ATF+4 (Automatic Transmission Fluid). Use of improper or substitute fluids can cause shift problems and/or transaxle failure.

1. Raise vehicle on hoist.
2. Obtain suitable fluid collection container and place under transaxle.
3. Remove transaxle drain plug (2). Allow fluid to drain into container until empty.
4. Install the drain plug (1) with a new gasket and tighten to 39 Nm (29 ft. lbs.).
5. Remove transaxle fill plug (1).
6. Add the appropriate amount of transaxle fluid to the transaxle.