Installation

INSTALLATION

DOMESTIC




1. Attached wire to new cable. Pull fender out and insert cable into opening.

2. Pull cable through hole in kick panel area using the attached wire.

3. Connect antenna body cable to the instrument panel cable (5).

4. Install right kick panel trim.

5. Install bezel adapter.

6. Install mounting nut.

7. Install cover.

8. Install antenna mast. Tighten to 50 Nm (37 ft. lbs.). Ensure that the antenna mast is fully seated on antenna base and that there is no gap between the mast and base.

9. Tighten fender mounting bolts near door hinge area.

10. Install and tighten the upper fender mounting bolts.

11. Connect the battery negative cable.

EXPORT

WARNING: Disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, side airbag, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury.




1. Connect antenna cable (1) to the instrument panel antenna cable.

2. Install antenna cable to the roof panel by pressing retaining clips into position.

3. Connect antenna cable to the antenna module (2).

4. Raise headliner into position.

5. Install A-pillar trim.

6. Install the right side sunvisor.

7. Install the assist handles.

8. Connect the battery negative cable.