Installation

INSTALLATION




1. Install the swing gate (4) and install the bolts (2).

2. Tighten the bolts to 31 Nm (23 ft. lbs.).

3. Adjust the swing gate as needed adding 3 mm on the right side to compensate for sag after the spare tire is installed. (Refer to 23
- BODY/SWING GATE/SWING GATE - ADJUSTMENTS)

4. Connect the wire harness electrical connector.

5. Connect the check strap. (Refer to 23 - BODY/SWING GATE/CHECK STRAP - INSTALLATION)

6. Install the quarter trim panel. (Refer to 23 - BODY/INTERIOR/QUARTER TRIM PANEL - INSTALLATION)

Spare Tire Installation

1. Install the spare tire onto the studs on the carrier.

2. Install the two lug nuts and one wheel lock (if equipped). Tighten the nuts to 115 Nm (85 ft.lbs.)

3. Close the plastic wheel cover and install the two mounting bolts. Tighten the nuts to 115 Nm (85 ft.lbs.) (Cherokee model)

4. Close the license plate to cover the bolts and latch. (Cherokee model)