Lamp

LAMP




1. Position the lamp (2) and bracket (1) unit onto the light bar reinforcement (3).

NOTE: There is a hook on the forward edge of the lamp bracket that must be secured under a tab that is integral to the reinforcement. The rear of the lamp must be lifted upward by the lamp socket/connector in order to engage the hook under the tab.

2. Lift the lamp socket/connector on the rear of the lamp upward far enough to engage the hook (4) on the front edge of the lamp bracket under the integral tab (5) of the reinforcement.

3. Slide the lamp and bracket forward and seat.




4. Install and tighten the two screws (3) that secure the rear of the lamp bracket (4) to the reinforcement (1). Tighten the screws to 2 Nm (17 in. lbs.).

5. Reconnect the light bar wire harness connector (5) to the socket on the back of the lamp (2).

6. Reconnect the battery negative cable.

7. Confirm proper lamp alignment.

8. Reinstall the cover over the light bar lamps and reinforcement.