Installation

LAMP




1. Position the headlamp unit (2) to the grille opening reinforcement (4).

2. Reconnect the wire harness connectors to the headlamp bulb socket (North America), the headlamp bulb base (Export), the front position lamp socket (if equipped), and the headlamp leveling motor (if equipped).

3. Engage the locator tab (5) on the outboard side of the headlamp unit into the engagement slot in the outboard edge of the grille opening reinforcement.

4. Align the two mounting tabs (3) on the inboard side of the headlamp unit housing to the mounting holes in the grille opening reinforcement.

5. Install and tighten the two screws that secure the mounting tabs on the inboard side of the headlamp housing to the grille opening reinforcement. Tighten the screws to 3 Nm (30 in. lbs.).

6. Reinstall the grille panel onto the grille opening reinforcement.

7. Reconnect the battery negative cable.

8. Confirm proper headlamp unit alignment.