Removal

LAMP




1. Disconnect and isolate the battery negative cable.

2. Open the tailgate to access and remove the two screws (5) that secure the rear lamp unit (4) to the two plastic nuts (1) in the side jamb of the tailgate opening.

3. Pull the outboard side of the rear lamp unit rearward far enough to unsnap the two ball studs on the outboard side of the lamp housing from the two plastic grommets (3) in the quarter panel.

4. Disconnect the wire harness connector (2) from the lamp socket plate connector.

5. Remove the lamp from the quarter panel.

6. Remove the two plastic grommets from the quarter panel and discard.