Installation

LAMP

NOTE: Side repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.




1. Position the repeater lamp unit (1) to the front fender panel (2).

2. Reconnect the wire harness connector to the lamp socket.

3. Position the lamp unit into the mounting hole in the front fender panel. Be certain that the clearance notch on the edge of the lamp lens is oriented towards the bottom.

4. Using hand pressure, press on the lamp lens firmly and evenly until the snap features of the lamp are fully engaged in the mounting hole of the front fender panel.

5. Reconnect the battery negative cable.