Installation

INSTALLATION
1. Reconnect the power seat wire harness connector to the power seat switch connector receptacle.

2. Position the power seat switch onto the outboard seat cushion side shield. Make certain the alignment dowel is inserted into the corresponding hole in the power seat switch.

3. Install and tighten the two screws that secure the power seat switch to the inside of the outboard seat cushion side shield. Tighten the screws to 1.5 Nm (14 in. lbs.).

4. Position the outboard seat cushion side shield onto the seat cushion frame

5. Install and tighten the two screws that secure the outboard seat cushion side shield to the seat cushion frame. Tighten the screws to 1.5 Nm (14 in. lbs.).

6. Install the recliner handle and retaining screw. Tighten the screws to 1.5 Nm (14 in. lbs.).

7. Position the power seat switch knob onto the switch control levers and push firmly and evenly until it snaps into place.

8. Reconnect the battery negative cable.