Installation

INSTALLATION

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, occupant classification system, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.

NOTE: A light bar lamp switch is used only on vehicles equipped with the optional light bar and auxiliary off-road lamps.




1. From the face of the driver side outboard bezel (1), align the light bar lamp switch housing (2) to the mounting hole in the bezel.

2. Push the switch into the mounting hole until it is fully seated and each of the latch features is fully engaged.

3. Reconnect the instrument panel wire harness connector to the switch connector receptacle.

4. Reinstall the trim bezel and switch unit onto the instrument panel.

5. Reconnect the battery negative cable.