Battery - Removal

REMOVAL

WARNING: Wear a suitable pair of rubber gloves (not the household type) when removing a battery by hand. Safety glasses should also be worn. If the battery is cracked or leaking, the electrolyte can burn the skin and eyes.






NOTE: The use of a battery terminal puller (2) may be necessary if the cable clamps will not separate from the battery posts.




1. Turn the ignition switch to the Off position. Be certain that all electrical accessories are turned off.

2. Loosen the battery negative cable (5) terminal clamp pinch-bolt hex nut.

3. Disconnect the battery negative cable (5) terminal clamp from the battery negative terminal post. If necessary, use a battery terminal puller to remove the terminal clamp from the battery post.

4. Loosen the battery positive cable (6) terminal clamp pinch-bolt hex nut.

5. Disconnect the battery positive cable (6) terminal clamp from the battery positive terminal post. If necessary, use a battery terminal puller to remove the terminal clamp from the battery post.

6. Remove the battery holddowns from the battery.

7. Remove the battery and the battery thermal guard (if equipped) from the battery tray as a unit.

8. If equipped, remove the battery thermal guard from the battery case.