Removal - RHD

REMOVAL - RHD

The following junction block removal procedure applies to Right Hand Drive (RHD) vehicles only.

1. Disconnect and isolate the negative battery cable.

2. Remove the right end cap from the instrument panel.

3. Unsnap and remove the right outboard trim bezel from the instrument panel. Located just to the right of the steering column.

4. Remove the steering column opening cover.

5. Remove the right cowl trim panel from the vehicle.

6. Remove the courtesy lamp from under the right side of the instrument panel. This will allow sufficient room to remove the junction block from under the instrument panel.

7. Working through the steering column opening cover, remove the three bulkhead and two body controller electrical connectors from the junction block assembly.

8. Remove the two ground wires from the right lower kick panel area. Located directly behind the kick trim panel. This will allow sufficient room to remove the junction block from under the instrument panel.

9. Remove the upper and forward most (in relation to the vehicle) group of relays from the junction block. This will allow sufficient room to remove the junction block from under the instrument panel.

10. Remove the four junction block retaining screws and remove the junction block from under the instrument panel. It will be necessary to position the under instrument panel wire harness out of the way to remove the junction block.