Installation

LAMP




1. Check to be certain that the two plastic nuts (6) are properly positioned and in good condition on each side of the roof panel (1) opening for the Center High Mounted Stop Lamp (CHMSL) (4).

2. Position the CHMSL near the roof panel opening.

3. Reconnect the wire harness connector (2) to the CHMSL socket (3).

4. Install and tighten the two screws (5) that secure the CHMSL to the roof panel. Tighten the screws to 2 Nm (21 in. lbs.).

5. Reconnect the battery negative cable.