Installation

LAMP

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, occupant classification system, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.




1. Position the courtesy lamp unit (1) under the instrument panel.

2. Reconnect the instrument panel wire harness connector to the back of the courtesy lamp.

3. Position the courtesy lamp to the lower instrument panel (3).

4. Install and tighten the screw (2) that secures the integral mounting tab of the courtesy lamp to the lower instrument panel. Tighten the screw to 2 Nm (17 in. lbs.).

5. Reconnect the negative battery cable.