Installation

INSTALLATION




1. Apply a coat of hypoid gear lubricant to differential bearings, bearing cups and threaded adjusters.

NOTE: Grease can be used to keep the adjusters in position.

2. Install differential assembly into the housing.
3. Install differential bearing caps in their original locations.
4. Install bearing cap bolts (2) and tighten upper bolts to 14 Nm (10 ft. lbs.). Tighten lower bolts finger-tight until bolt head is seated.




5. Perform differential bearing preload adjustment procedure with Wrench C-4164 (3).
6. Tighten bearing cap bolts in a criss-cross pattern to 95 Nm (70 ft. lbs.).
7. Install adjuster locks on bearing caps and tighten to 10 Nm (90 in. lbs.).




8. Install axle shaft (1) in axle tube (2) and engage into side gear splines.




9. Lubricate bearing bore and seal lip with gear lubricant.
10. Install C-lock (1) in axle shaft end, then push axle shaft outward to seat C-lock in side gear.




11. Install pinion mate shaft (1) into differential case (2) and through thrust washers and differential pinions.




12. Align hole in mate shaft (1) with hole in the differential case. Apply Mopar Lock & Seal Adhesive or Loctite(R) to lock screw (2) threads. Install lock screw and tighten to 11 Nm (8 ft. lbs.).
13. Install differential cover.