Installation

INSTALLATION





CAUTION: Do not reuse Balance Shaft Module (BSM) to engine block bolts. Always discard bolts after removing. Failure to replace bolts can result in engine damage.

1. Clean BSM mounting holes Mopar(R) brake parts cleaner.
2. If chain was removed, align marks on crankshaft sprocket (2) and chain (1).
3. Align marks on oil pump sprocket (5) and chain (4).
4. Install chain on sprocket.
5. Pivot BSM assembly upwards and position on ladder frame.




6. Start new BSM mounting bolts by hand.

NOTE: Use a three step procedure when torquing BSM mounting bolts.

7. Tighten BSM mounting bolts to 15 Nm (11 ft. lbs.) as shown.
8. Tighten BSM mounting bolts to 29 Nm (22 ft. lbs.) as shown.
9. Rotate bolts an additional 90� as shown.




10. Remove tensioner pin 9703 (4).
11. Install oil pan.
12. Fill with oil.
13. Start engine and check for leaks.