Pedal Positioning System: Service and Repair

ADJUSTABLE PEDALS

REMOVAL

NOTE: If possible put the pedals in the full forward position.

1. Disconnect the negative battery cable.
2. Remove the power brake booster.





3. Remove the 2 intermediate shaft bearing nuts (1).
4. Remove the lower steering shaft pinch bolt.
5. Remove the lower steering shaft off the column.
6. Lock the steering wheel into place.
7. Disconnect the pedal motor electrical connector.
8. Disconnect the accelerator pedal cable.





9. Disconnect the 2 accelerator pedal mounting nuts (4).





10. Loosen the brake pedal sled (1) upper nuts
11. Remove the brake pedal/accelerator pedal assembly (2&3) from the vehicle.

INSTALLATION





1. Install the pedal assembly (2) to the vehicle.
2. Tighten the upper brake pedal sled nuts (4).





3. Install and tighten the 2 accelerator pedal (2) nuts to 28 Nm (21 ft. lbs.).
4. Reconnect the accelerator pedal cable.
5. Reconnect the pedal motor electrical connector.





6. Install the lower steering shaft to the column.
7. Install the lower steering shaft pinch bolt at the column.
8. Unlock the steering wheel.
9. Install the 2 intermediate shaft bearing nuts (1).
10. Install the power brake booster.
11. Reconnect the negative battery cable.
12. Fill and bleed brake system.