Chime/Buzzer

B210D-BATTERY VOLTAGE LOW

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
While the vehicle is in reverse for speeds less than 16km/h.

- Set Condition:
Park Assist Module supply voltage less than 9.0 volts.





Diagnostic Test

1. CHECK FOR ACTIVE DTC: B210D-BATTERY VOLTAGE LOW
Turn the ignition on.
Apply the vehicle park brake.
Shift the transmission into reverse.
With the scan tool, record and erase Park Assist Module DTCs.
Wait 30 seconds.
With the scan tool, read Park Assist Module DTCs.
Is DTC: B210D-BATTERY VOLTAGE LOW active?

Yes

- Go To 2

No

- The condition that caused this code to set is not present at this time. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

2. VERIFY OPERATION OF THE VEHICLE CHARGING SYSTEM
NOTE: Troubleshoot any PCM charging/cranking DTCs before proceeding.

NOTE: Make sure the battery is fully charged.

Are any charging system DTCs present?

Yes

- Refer to appropriate testing.

No

- Replace the Park Assist Module.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test