Power Locks

B210D-BATTERY VOLTAGE LOW - DOOR MODULE

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
At all times.

- Set Condition:
Anytime the module senses voltage input below 9.5 volts, this code will set.





Diagnostic Test

1. CHECK ENGINE DTC's
With the scan tool, read ENGINE DTC's
Are there any ENGINE DTC's present?

No

- Go to 2

Yes

- Refer to symptom list for problems related to ENGINE.

2. TEST FOR INTERMITTENT CONDITION
With the scan tool, record and erase DTC's
Start the engine and run for 2 minutes.
Cycle the ignition from on to off 3 times.
Turn the ignition on.
With the scan tool, read DTC's.
Does the scan tool display B210D-BATTERY VOLTAGE LOW?

Yes

- Replace the appropriate Door Module.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test