Restraints

B222A-VEHICLE LINE MISMATCH

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
The ORC checks its feature configuration for a stored Model Year, Vehicle Line, Country Code, and Body Style continuously 12 seconds after initialization.

- Set Condition:
This DTC sets when the ORC detects a mismatch between the Vehicle Configuration and the ORC configuration.





Diagnostic Test

1. DETERMINE ACTIVE OR STORED DTC
NOTE: Ensure the battery is fully charged.

Turn the ignition on.
Wait 12 seconds, with the scan tool, read all active ORC DTCs.
Is the DTC active or stored?

ORC - ACTIVE DTC

- Go To 2

ORC - STORED DTC

- Go To 3

2. CHECK THE TIPM COUNTRY CODE, VEHICLE LINE AND BODY STYLE
With the scan tool, check for the correct Country Code, Vehicle Line and Body Style.
Does the Vehicle Configuration in the TIPM match the Vehicle Configuration in the ORC?

Yes

WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and serious or fatal injury.

WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

- Replace the ORC.

No

- Replace or re-configure the Totally Integrated Control Module (TIPM).

3. TEST FOR INTERMITTENT CONDITION
With the scan tool, record and erase all DTCs from all Airbag modules.
If any ACTIVE codes are present they must be resolved before diagnosing any stored codes.

WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
Look for chafed, pierced, pinched, or partially broken wires and broken, bent, pushed out, spread, corroded, or contaminated terminals.
The following additional checks may assist you in identifying a possible intermittent problem.
Reconnect any disconnected components and harness connector.

WARNING: To avoid serious or fatal injury, turn the ignition on, then reconnect the battery.

With the scan tool, monitor active codes as you work through the following steps.

WARNING: To avoid serious or fatal injury, maintain a safe distance from all airbags while performing the following steps.

Wiggle the wiring harness and connectors of the related airbag circuit or component.
If codes are related to the Driver Airbag circuits, rotate the steering wheel from stop to stop.
If only stored codes return, continue the test until the problem area has been isolated.
In the previous steps you have attempted to recreate the conditions responsible for setting the active DTC in question.
Does the scan tool display any ACTIVE DTCs?

Yes

- Select appropriate symptom from Symptom List.

No

- No problem found at this time. Perform the *ORC VERIFICATION TEST - VER 1. Verification Tests in this Section. Erase all codes before returning vehicle to customer.