B2302

B2302-WIPER MODE SWITCH INPUT CIRCUIT HIGH (SCM)

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
- With the ignition on.
- Set Condition:
- When the Steering Control Module detects a short/HIGH condition.





Diagnostic Test

1. INTERMITTENT CONDITION
Turn the ignition on.
With the Scan Tool, clear all CCN DTC's.
Turn the Wipers ON then OFF.
With the Scan Tool, read the Wiper DTC's.
Does the Scan Tool read: B2302-WIPER MODE SWITCH INPUT CIRCUIT HIGH?

Yes

- Go To 2

No

- The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
- Perform the BODY VERIFICATION TEST - VER 1.Body Verification Test

2. MULTIFUNCTION SWITCH
Turn the ignition off.
Using the correct service procedure, remove the Wiper Multi-Function Switch.
Measure the internal resistance of the Multifunction Switch between cavities 7 and 9. Move the switch position from OFF to HIGH while measuring.
OFF = 1581 ohms
DELAY 1 = 695 ohms
DELAY 2 = 463 ohms
DELAY 3 = 323 ohms
DELAY 4 = 232 ohms
DELAY 5 = 169 ohms
LOW = 96 ohms
HIGH = 0 ohms
Is the resistance in each position correct?

Yes

- Replace the Steering Control Module.
- Perform the BODY VERIFICATION TEST - VER 1.Body Verification Test

No

- Replace the Multifunction Switch.
- Perform the BODY VERIFICATION TEST - VER 1.Body Verification Test