B232E

B232E-REAR WASHER SWITCH STUCK (SCM)

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
With the ignition on.

- Set Condition:
The SCM detects the Rear Washer Switch in the STUCK state.





Diagnostic Test

1. INTERMITTENT CONDITION
Turn the ignition on.
With the Scan Tool, clear all SCM DTC's.
Turn the Wipers ON then OFF.
With the Scan Tool, read the Wiper DTC's.
Does the Scan Tool read: B232E-REAR WASHER SWITCH STUCK (SCM)?

Yes

- Go To 2

No

- The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
- Perform the BODY VERIFICATION TEST - VER 1.Body Verification Test

2. WIPER MULTIFUNCTION SWITCH
Turn the ignition off.
Using the correct service procedure, remove the Wiper Multi-Function Switch.
Measure the internal resistance of the Multifunction Switch between cavities 4 and 5. Move the switch into the WASH position while measuring.
WASH = 0 ohms
Is the resistance in the WASH position correct?

Yes

- Replace the Steering Control Module.
- Perform the BODY VERIFICATION TEST - VER 1.Body Verification Test

No

- Replace the Multifunction Switch.
- Perform the BODY VERIFICATION TEST - VER 1.Body Verification Test