C2113

C2113-DRIVETRAIN SENSOR SUPPLY VOLTAGE CIRCUIT OPEN (FDCM)





For a complete wiring diagram Consult Diagrams/Electrical

- When Monitored:
With the ignition on and no system undervoltage or overvoltage condition present.

- Set Condition:
The Final Drive Control Module detects that the 5V Supply (Reference) Voltage is correct, but the Transfer Case Selector Switch and Mode Sensor indicate a low voltage condition.





Diagnostic Test

1. DTC IS ACTIVE
Ignition on, engine not running.
With the scan tool, read DTCs in the FDCM.
Is the status Active for this DTC?

Yes

- Go to 2

No

- Go to 4


2. (K504) DRIVETRAIN 5 VOLT SUPPLY CIRCUIT OPEN




Turn the ignition off to the lock position
Disconnect the Transfer Case Motor harness connector.
Disconnect the Final Drive Control Module C2 harness connector.
Measure the resistance of the (K504) Drivetrain 5-volt Supply circuit between the Transfer Case Motor harness connector and the Final Drive Control Module C2 harness connector.
Is the resistance above 5.0 ohms?

Yes

- Repair the (K504) Drivetrain 5-volt Supply circuit for an open.
- Perform the TRANSFER CASE VERIFICATION TEST-VER 1Transfer Case Verification Test.

No

- Go to 3

3. (K594) DRIVETRAIN SENSOR RETURN CIRCUIT OPEN




Measure the resistance of the (K594) Drivetrain Sensor Return circuit between the Transfer Case Motor harness connector and the Final Drive Control Module C2 harness connector.
Is the resistance above 5.0 ohms?

Yes

- Repair the (K594) Drivetrain Sensor Return circuit for an open.
- Perform the TRANSFER CASE VERIFICATION TEST-VER 1Transfer Case Verification Test.

No

- Replace the Final Drive Control Module.
- Perform the TRANSFER CASE VERIFICATION TEST-VER 1Transfer Case Verification Test.

4. INTERMITTENT WIRING AND CONNECTORS
The conditions necessary to set this DTC are not present at this time.
Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
While monitoring the scan tool data relative to this circuit, wiggle test the wiring and connectors.
Look for the data to change or for the DTC to reset during the wiggle test.
Were any problems found?

Yes

- Repair as necessary.
- Perform the TRANSFER CASE VERIFICATION TEST-VER 1Transfer Case Verification Test.

No

- Test complete.