Air Cleaner Housing - Removal

REMOVAL





1. Disconnect the negative battery cable.
2. Disconnect the MAF (4) and air pressure sensor (3) electrical connectors.
3. Remove the air outlet hose from the air cleaner assembly.
4. Pry up two spring clips (1) from front of housing cover (2) (spring clips retain cover to housing).
5. Release housing cover (2) from locating tabs located on rear of housing, and remove cover (2).
6. Remove the rear lower housing to fender well fastener.
7. Remove the air inlet duct.
8. Pulling upward, remove the air cleaner housing.
Intake Air Tube

1. Remove the CCV hose at Oil separator. (During removal of the CCV hose do NOT disconnect CCV hose at the Air Tube)
2. Loosen the clamp on the Airbox outlet flex hose end.
3. Loosen the clamp on the Turbo inlet end.
4. Remove the retaining fastener.
5. Remove the intake air tube and ensure that Orange seal is not rolled or damaged.

NOTE: any incorrect installation or miss alignment of the air tube can result oil leaks.