Installation

INSTALLATION





WARNING: Use tongs or welding gloves when handling heated components. Failure to follow these instructions will result in personal injury.

CAUTION: A bearing heater (2) is used to heat differential bearings (1). Use only a bearing heater/hot plate and follow manufacturer's instructions. Heat components to 100 - 177 Celsius (212° Min. - 350° Max Fahrenheit). Never use an open flame to heat components. Never leave components on heater for an extended amount of time. If component is discolored after heating, the component has been overheated and must not be used. Failure to follow these instructions will result in component damage.

1. Heat bearing (1) to a maximum of 177 Celsius (350° Fahrenheit) with bearing heater (2).




2. With tongs or welding gloves install bearing (1) on differential case (2). Bearing can also be installed with Installer C-4213 and Handle C-4171.