Left

NOTE: The four smaller cylinder head mounting bolts require sealant to be added to them before installing. Failure to do so may cause leaks.

NOTE: The cylinder head bolts are tightened using an angle torque procedure.

Tighten the bolts in sequence using the following steps and torque values:
- Step 1: Tighten bolts 1-10, 20 Nm (15 ft. lbs.).
- Step 2: Tighten bolts 1-10, 47 Nm (35 ft. lbs.). Tighten bolts 11-14, 25 Nm (18 ft. lbs.).
- Step 3: Tighten bolts 1-10, 90 degrees. Tighten bolts 11-14, 30 Nm (22 ft. lbs.).