Engine - Installation

INSTALLATION - ENGINE





1. Install Engine Lift Fixture 8984 and 8984-UPD.
2. Position the engine in the engine compartment.
3. Lower the engine into compartment and align engine with transmission.




4. Mate engine (1) and transmission (3) and install two transmission to engine block mounting bolts (2) finger tight.




5. Lower engine assembly until the engine mounts (2) rests in frame perches (1).








6. Install remaining transmission to engine block mounting bolts (2) and the oil pan to transmission bolts (1) and tighten.




7. Install and tighten engine mount to frame bolts (3) and nuts.




8. Install drive plate to torque converter bolts (1).
9. Install the structural dust cover (1).




10. Install the starter (1) and connect the starter wires. Starter Motor - Installation
11. Install the exhaust pipe to manifold.
12. Lower the vehicle.




13. Remove Engine Lift Fixture 8984 (2), and Adapter 8984-UPD.








14. Connect the fuel supply line. Service and Repair
15. Reinstall the power steering pump.
16. Connect the heater hoses (1).




17. Reconnect the ground wires to the rear of each cylinder head.
18. Install the intake manifold. Intake Manifold - Installation
19. Install the generator (2), and wire connections. Generator - Installation




20. Install the A/C Compressor (3). A/C Compressor - Installation




21. Install the accessory drive belt. Accessory Drive Belt - Installation
22. Install the radiator fan shroud.
23. Connect the radiator lower hose.
24. Connect the transmission oil cooler lines to the radiator.
25. Connect the radiator upper hose.




26. Install the air cleaner resonator and duct work.
27. Add engine oil to crankcase. Specifications
28. Fill the cooling system. Service and Repair
29. Install the engine cover (1).




30. Install the strut tower support (1).
31. Connect battery negative cable.
32. Start engine and inspect for leaks.
33. Road test vehicle.