Rear Washer Nozzle - Description

REAR





The fluidic rear washer nozzle (4) is constructed of molded plastic. The rear washer nozzle is secured by an integral latch feature (1) and two integral alignment pins (5) within a mount integral to the lens of the Center High-Mounted Stop Lamp (CHMSL) on the outer liftgate panel above the rear flip-up glass opening.

The domed outer surface of the washer nozzle is visible on the lower exterior surface of the CHMSL, and a rubber O-ring (3) seals the nozzle to the lamp lens. The nozzle orifice is oriented downward towards the liftgate glass. The washer plumbing fitting (2) is concealed between the liftgate outer and inner panels.

The rear washer nozzle cannot be adjusted or repaired and, if ineffective or damaged, it must be replaced.