Sunroof - Installation

INSTALLATION






WARNING: The Excessive Force Limitation (EFL) feature must be calibrated any time a sunroof motor/module is replaced with a new component. Failure to perform this procedure could result in vehicle damage and/or personal injury. Programming and Relearning CALIBRATION) for the appropriate procedure.

1. Verify that glass panel is loose and slightly retracted.
2. Raise sunroof module assembly and guide it carefully into position.
3. Hand start the eight screws (3).
4. Line up the locating holes and tighten the attaching screws (3) to 9 Nm (80 in. lbs.).





5. Install the DVD support bracket (3), if equipped.
6. Install the bolts (2) and tighten to 9 Nm (80 in. lbs.).
7. Install the bolts (1) and tighten to 10 Nm (85 in. lbs.).





8. Connect the electrical connector (2) and seat the three support clips (1) fully.





9. Connect the front (1) and rear (2) drain tubes to the sunroof.
10. Adjust the sunroof glass. Adjustments
11. Connect battery negative cable.
12. Install the vehicle headliner, Headliner - Installation.
13. Perform the sunroof position calibration, Programming and Relearning.
14. Perform the Excessive Force Limitation (EFL) calibration,Programming and Relearning.
15. Verify proper operation of the power sunroof system.