Rear

LAMP

NOTE: The following procedure applies only to vehicles manufactured for certain export markets where rear fog lamps are optional or required equipment. Rear fog lamps are not available in vehicles manufactured for North American markets.





1. Position the rear fog lamp (2) to the back of the rear fascia (1).
2. Engage the two tabs (3) on the outboard side of the lamp into the slots in the fascia.
3. Position the mounting tab on the inboard side of the lamp to the fascia.
4. Install and tighten the screw (5) that secures the lamp to the back of the fascia. Tighten the screw to 3 Nm (27 in. lbs.).
5. Align the socket and bulb (4) with the keyed opening on the bottom of the lamp housing.
6. Insert the socket and bulb into the housing until the socket is firmly seated.
7. Rotate the socket clockwise about 30 degrees to lock it into place.
8. Reinstall the fascia support to the back of the rear fascia.
9. Reinstall the bumper fascia onto the rear of the vehicle. Rear Bumper Fascia - Installation.
10. Reconnect the battery negative cable.