Operation CHARM: Car repair manuals for everyone.

U0151






U0151-LOST COMMUNICATION WITH OCCUPANT RESTRAINT CONTROLLER (ORC)





For a complete wiring diagram, refer to the Wiring Information Electrical Diagrams.

- When Monitored:
With the ignition on.

Battery voltage between 10 and 16 volts.

Airbag fuse installed.

Totally Integrated Power Module (TIPM) is configured correctly.

- Set Condition:
Bus messages not received from the Occupant Restraint Controller (ORC) for approximately two to five seconds.





1. VERIFY THE DIAGNOSTIC TROUBLE CODE (DTC) IS ACTIVE

NOTE: Make sure the IOD fuse is installed and battery voltage is between 10 and 16 volts before proceeding.

NOTE: Check for any TSB(s) related to the condition. If a TSB applies, perform the procedure outlined in the TSB before continuing.

1. Using the scan tool, read active DTCs.

Is this DTC active?

Yes

- Go To 2

No

- Perform the Stored Lost Communication diagnostic procedure. Stored Lost Communication DTCs.

2. CHECK FOR ANY OF THE FOLLOWING ACTIVE DTCS
1. Using the scan tool, read all active DTCs from all modules.

NOTE: Check for TIPM configuration, CAN B or C hardware electrical, VIN Missing/Mismatch, battery or ignition related DTCs.

Does the scan tool display any active DTCs to the conditions listed above?

Yes

- Perform the appropriate diagnostic procedure.

No

- Go To 3

3. VERIFY THAT THE ORC IS ACTIVE ON THE BUS
1. Turn the ignition on.
2. Using the scan tool, select ECU View.
3. Verify that the ORC is active on the bus.

Is the ORC active on the bus?

Yes

- Go To 4

No

- No Response From ORC (Occupant Restraint Controller Module) Perform the No Response from ORC diagnostic procedure.

4. CHECK FOR ADDITIONAL COMMUNICATION RELATED DTC'S
1. Using the scan tool, select Network View and select Advanced.

Is there more than one module with active DTCs "Logged Against" the ORC?

Yes

- Replace/update the Occupant Restraint Controller.
- Perform the AIRBAG SYSTEM VERIFICATION TEST. Airbag System Verification Test.

No

- Replace/update the module that set this DTC
- Perform the appropriate VERIFICATION TEST. Verification Tests