Front

LAMP





1. Position the front fog lamp into the seat in the face of the front fascia. Be certain that the two alignment pins (2) on the back of the lamp housing are engaged in the alignment holes in the seat.
2. Install and tighten the two screws (3) that secure the lamp to the back of the fascia. Tighten the screws to 1.5 Nm (14 in. lbs.).
3. Reconnect the wire harness connector (4) to the fog lamp bulb socket (1).
4. On vehicles with a diesel engine only, reinstall the plastic push-in fasteners that secure the front wheelhouse splash shield to the front fascia. Splash Shield - Installation.
5. Lower the vehicle.
6. Reconnect the battery negative cable.
7. Confirm proper front fog lamp alignment. Adjustments.