Park Assist Module - Removal

REMOVAL





1. Disconnect and isolate the battery negative cable.
2. Remove the rear seat cushion from the rear floor panel (1). Seat Cushion Cover - Removal.
3. Disconnect the underbody wire harness connector (2) from the park assist module (3) connector receptacle. Vehicles with the front park assist option will have a second connection to the module at this location, which must also be disconnected.
4. Using a trim stick or another suitable wide flat-bladed tool, gently pry the two latch features on the inboard side of the mounting plate (4) away from the mounting tabs of the module far enough to disengage the inboard (connector) side of the module.
5. Pull the module inboard far enough to disengage the two mounting tabs on the outboard side of the module from the slots in the mounting plate.
6. Remove the module from the mounting plate.