Half Shaft - Installation

INSTALLATION





1. Install half shaft on the axle and through the hub/bearing. Verify half shaft has engaged.
2. Install shock clevis (3) on lower control arm and tighten nut to specifications.
3. Install upper control arm on knuckle and tighten ball joint nut to specifications.





4. Install tie rod end (4) on knuckle and tighten to specifications.
5. Install stabilizer link (3) on lower control arm and tighten to specifications.





6. Install caliper (1) on caliper adapter (4) and tighten to specifications.





7. Install wheel speed sensor (1) on the hub/bearing (3).
8. Install half shaft hub/bearing nut and tighten to 135 Nm (100 ft. lbs.).