B184F

B184F-FLIPPER GLASS CONTROL CIRCUIT HIGH





For a complete wiring diagram, refer to the wiring information Electrical Diagrams.

- When Monitored:
Continuously

- Set Condition:
When the TIPM senses a high condition on the Flip-UP (Flipper) Glass Relay Output circuit for over 5 seconds, this code will set.





1. TEST FOR INTERMITTENT CONDITION
1. With the scan tool, record and erase DTCs
2. Operate the Flip-Up Glass Switch several times.
3. Cycle the ignition from on to off 3 times.
4. Turn the ignition on.
5. With the scan tool, read DTCs.

Does the scan tool display B184F-FLIPPER GLASS CONTROL CIRCUIT HIGH?

Yes

- Go To 2

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. (Z920) GROUND CIRCUIT OPEN




1. Disconnect the Flip-Up Glass Latch C1 connector.
2. Using a test light connected to 12-volts check the (Z920) Ground circuit in the Flip-Up Glass C1 connector.

Does the test light illuminate brightly?

No

- Repair the (Z920) Ground circuit for an open.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

Yes

- Go To 3

3. FLIP-UP GLASS LATCH




1. Connect a 12-volt test light between the (Q81) Flip-Up Glass Relay output and the (Z920) Ground in Flip-Up Glass Latch connector.
2. With the scan tool actuate the Flip-Up Glass.

Does the test light illuminate brightly when the Latch is actuated?

Yes

- Replace the Flip-Up Glass Latch.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 4

4. (Q81) FLIP-UP GLASS RELAY OUTPUT CIRCUIT SHORT TO BATTERY




1. Measure the voltage between ground and the (Q81) Flip-Up Glass Relay Output circuit in the Flip-Up Glass Latch C1 connector.

Is there any voltage present?

Yes

- Repair the (Q81) Flip-Up Glass Relay Output circuit for a short to voltage.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 5

5. (Q81) FLIP-UP GLASS RELAY OUTPUT CIRCUIT OPEN




1. Turn the ignition off.
2. Disconnect the TIPM C7 connector.
3. Measure the resistance of the (Q81) Flip-Up Glass Relay Output circuit between the Flip-Up Glass Latch C1 connector and the TIPM C7 connector.

Is the resistance below 5.0 ohms?

No

- Repair the (Q81) Flip-Up Glass Relay Output circuit for an open.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

Yes

- Replace the Totally Integrated Power Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.