Front Fog Lamp Bulb - Installation

BULB - FRONT FOG LAMP

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.

CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.





1. Align the front fog lamp bulb and base (2) with the keyed opening on the back of the front lamp unit housing (1) located on the back of the front end module carrier.
2. Insert the bulb into the housing until the base is firmly seated.
3. Rotate the bulb base clockwise about 30 degrees to lock it into place. The bulb connector receptacle should be pointed straight downward.
4. Reconnect the wire harness connector to the connector receptacle integral to the front fog lamp bulb base.
5. Reconnect the battery negative cable.