Front Lamp Unit Bulb - Installation

BULB - HEADLAMP - DOMESTIC

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.

CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.





1. Align the headlamp bulb and base (2) with the keyed opening on the back of the front lamp unit (1) reflector located on the back of the front end module carrier.
2. Insert the bulb into the reflector until the base is firmly seated.
3. Rotate the bulb base clockwise about 30 degrees to lock it into place.
4. Reconnect the wire harness connector to the connector receptacle integral to the headlamp bulb base.
5. Reconnect the battery negative cable.