Park Assist Sensor - Removal

REMOVAL






NOTE: The park assist sensors (3) and the sensor spacers (O-rings) are each available for separate service replacement. The sensor brackets (5) are bonded to and integral to the back side of the rear bumper fascia (2).

1. Disconnect and isolate the battery negative cable.
2. Remove the rear wheel flare and loosen the bumper fascia on the same side of the vehicle as the park assist sensor requiring service. Rear Bumper Fascia - Removal.
3. From the back of the fascia (2), disconnect the wire harness connector (4) from the park assist sensor (3) connector receptacle.
4. Carefully pry the sensor bracket (5) latch features (1) away from the top and bottom latch tabs of the sensor far enough to disengage the sensor from the bracket.
5. Disengage the O-ring spacer from around the circumference of the sensor membrane protrusion.