Engine Controls - MIL ON/Multiple Ignition Coil DTC's
NUMBER: 18-028-09GROUP: Vehicle Performance
DATE: October 8, 2009
THE wiTECH DIAGNOSTIC APPLICATION IS THE PREFERRED METHOD FOR FLASHING ECUs. HELP USING THE wiTECH DIAGNOSTIC APPLICATION FOR FLASHING AN ECU IS AVAILABLE BY SELECTING "HELP" THEN "HELP CONTENTS" AT THE TOP OF THE wiTECH DIAGNOSTIC APPLICATION WINDOW.
THE wiTECH SOFTWARE LEVEL MUST BE AT RELEASE 10.01 OR HIGHER TO PERFORM THIS PROCEDURE.
StarMOBILE DESKTOP CLIENT or StarSCAN MAY ALSO BE USED TO PERFORM THIS PROCEDURE.
SUBJECT:
Flash: MIL Illumination P2302, P2305, P2308, P2311, P2314, P2317, P2610
OVERVIEW:
This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software.
MODELS:
2009 (KA) Nitro
2009 (KK) Liberty
2009 (WK) Grand Cherokee
2009 (WH) Grand Cherokee (International Markets)
2009 (XK) Commander
NOTE:
This bulletin applies to all 2009 WK/WH/XK vehicles equipped with a 3.7L engine (Sales code EKG) or 2009 KA/KK vehicles equipped with a 3.7L engine (Sales code EKG) built before April 16, 2009 (MDH0414XX).
SYMPTOM/CONDITION:
The customer may experience a MIL illumination for the Diagnostic Trouble Codes (DTC) shown.
DIAGNOSIS:
Using a Scan Tool (wiTECH(TM) or StarSCAN(R)) with the appropriate Diagnostic Procedures available in TechCONNECT, verify all engine systems are functioning as designed. If DTC's are present other then the ones listed above record them on the repair order and repair as necessary before proceeding further with this bulletin.
If the above condition is present, perform the Repair Procedure.
PARTS REQUIRED:
REPAIR PROCEDURE:
NOTE:
If this flash process is interrupted/aborted, the flash should be restarted.
1. Reprogram the PCM with the latest software. Follow the detailed service procedures available in DealerCONNECT/TechCONNECT, Refer To Group 8 - Electrical > Electronic Control Modules - Service Information > Module - Powertrain Control > Standard Procedures > PCM/ECM Programming - Gas. After PCM reprogramming, the following must be performed:
a. Clear any DTC's that may have been set in other modules due to reprogramming. The wiTECH application will automatically present all DTCs after the flash and allow the tech to clear them.
2. Type the necessary information on the "Authorized Modification Label and attach it near the VECI label.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.