Speed Control Switch - Installation

INSTALLATION





Mounting hole (1) uses a screw. Depending on model line, mounting holes (2) may use either two screws, or one screw and a locating pin.





1. Connect electrical connector to speed control switch.
2. Install speed control switch mounting screws.
3. Tighten screws (1) to 1.6 Nm (15 in. lbs.). Make sure rubber seal is in place around switch.





4. Install horn switch.
5. Install three mounting fasteners.
6. Connect electrical connector to clockspring.
7. Install driver airbag. Driver Air Bag - Installation

WARNING: Do not connect battery negative cable yet. Refer first to airbag system test. Component Tests and General Diagnostics

8. Reconnect battery using Airbag System Test procedure in Restraints. Component Tests and General Diagnostics
9. Close hood.
10. Verify vehicle and system operation.